DeWalt Recalls Framing Saws and Circular Saws for Laceration Hazard
CPSC Recall Notice
Source: U.S. Consumer Product Safety Commission (CPSC) — official agency notice for recall CPSC-3480.
This recall involves DeWalt DW378G and DW378GT 7 ¼-inch framing saws with date codes 200301-49 through 200637-49. The model numbers for the framing saws are located on the side of the housing. The date code is located either on the name plate or under the handle near the power cord exit. Circular saws involved in this recall have model number DC300 with date codes 200601-49 through 200637-49. The model number on the circular saw is located on the name plate on the top of the motor housing. The date code on the circular saw is located on the underside of the motor housing. Framing saws marked with a "V" on the underside of the handle near the cord set and circular saws marked with a "V" on the underside of the motor housing or under the handle where the battery is inserted have already been repaired and are not involved in this recall.
Corrective Action (per CPSC)
Source: U.S. Consumer Product Safety Commission (CPSC) — official agency notice for recall CPSC-3480.
Consumers should stop using the saws immediately and contact DeWalt for a free repair.
✅ What you should do
- Stop using the product if you own it.
- Check the model number, lot code, or sell-by date against the recall notice above.
- Contact Major Home Centers And Hardware Stores Nationwide From January 2003 Through August 2006 For About $170 For The Framing Saw. The Circular Saw Was Sold From May 2006 Through September 2006 For Between $380 And $800, Depending On The Kit. or the retailer where you bought it for a refund, replacement, or repair.
- For the most current official instructions, visit the CPSC recall page.
- If you've been hurt by this product, report the incident to CPSC.
Consumer Contact (per CPSC)
Source: U.S. Consumer Product Safety Commission (CPSC) — official agency notice for recall CPSC-3480.
For additional information, consumers can contact DeWalt toll-free at (866) 854-5214 between 8 a.m. and 5 p.m. ET Monday through Friday, or visit the firm's Web site at www.dewalt.com
About the U.S. Consumer Product Safety Commission
The CPSC protects consumers from injuries and deaths from thousands of types of consumer products — toys, furniture, electronics, appliances, and more.
Visit CPSC.gov →📣 Report an unsafe product to the CPSC
If you own this product and experienced a defect, near-miss, or injury, file a report with the CPSC. Consumer reports are the primary signal the agency uses to identify defect patterns and trigger future recalls. Your report is free, takes about 10 minutes, and can stay anonymous to the manufacturer.
Major Home Centers And Hardware Stores Nationwide From January 2003 Through August 2006 For About $170 For The Framing Saw. The Circular Saw Was Sold From May 2006 Through September 2006 For Between $380 And $800, Depending On The Kit. Recall FAQ
Major Home Centers And Hardware Stores Nationwide From January 2003 Through August 2006 For About $170 For The Framing Saw. The Circular Saw Was Sold From May 2006 Through September 2006 For Between $380 And $800, Depending On The Kit. is the subject of a tools recall: DeWalt Recalls Framing Saws and Circular Saws for Laceration Hazard. The notice was published on November 8, 2006 by the U.S. Consumer Product Safety Commission (CPSC). Approximately 97,000 units are potentially affected.