CPSC, Sears Roebuck and Co. Announce Recall of Table Saw Rip Fences
CPSC Recall Notice
Source: U.S. Consumer Product Safety Commission (CPSC) — official agency notice for recall CPSC-2909.
The rip fence on these saws is made of silver extruded aluminum, is 31inches in length, and has an over-locking handle with a black die-cast aluminum head. They were included with Craftsman table saw model number 137.21830.
Corrective Action (per CPSC)
Source: U.S. Consumer Product Safety Commission (CPSC) — official agency notice for recall CPSC-2909.
The firm will provide free replacement parts with instructions to consumers.
✅ What you should do
- Stop using the product if you own it.
- Check the model number, lot code, or sell-by date against the recall notice above.
- Contact Sears Stores Nationwide, From August 2002 Through November 2004. The Cost Of Complete Table Saw Is About $399, And The Cost Of The Rip Fence Is About $40. or the retailer where you bought it for a refund, replacement, or repair.
- For the most current official instructions, visit the CPSC recall page.
- If you've been hurt by this product, report the incident to CPSC.
Consumer Contact (per CPSC)
Source: U.S. Consumer Product Safety Commission (CPSC) — official agency notice for recall CPSC-2909.
For additional information, contact the Sears Craftsman Helpline at (800) 843-1682 between 8:30 a.m. and 7 p.m. ET Monday through Friday.
About the U.S. Consumer Product Safety Commission
The CPSC protects consumers from injuries and deaths from thousands of types of consumer products — toys, furniture, electronics, appliances, and more.
Visit CPSC.gov →📣 Report an unsafe product to the CPSC
If you own this product and experienced a defect, near-miss, or injury, file a report with the CPSC. Consumer reports are the primary signal the agency uses to identify defect patterns and trigger future recalls. Your report is free, takes about 10 minutes, and can stay anonymous to the manufacturer.
Sears Stores Nationwide, From August 2002 Through November 2004. The Cost Of Complete Table Saw Is About $399, And The Cost Of The Rip Fence Is About $40. Recall FAQ
Sears Stores Nationwide, From August 2002 Through November 2004. The Cost Of Complete Table Saw Is About $399, And The Cost Of The Rip Fence Is About $40. is the subject of a furniture recall: CPSC, Sears Roebuck and Co. Announce Recall of Table Saw Rip Fences. The notice was published on April 7, 2005 by the U.S. Consumer Product Safety Commission (CPSC). Approximately 41,800 units are potentially affected.